Publicité
Les langues disponibles
Les langues disponibles
5. Keep engine and parts clean.
6. Check engine and equipment often for loose nuts and bolts, keep these items tightened.
CHECK OR FILL ENGINE CRANKCASE
1. Add oil according to engine manual. Do not overfill. Use a clean, high quality detergent oil. Do not mix oil
with gasoline.
Oil level must be full. check the oil level by removing oil fill plug. Oil level should be up to the bottom of
the fill plug opening.
2. Always check oil level before starting engine. Refer to engine manual for capacity and type of oil to use.
IMPORTANT
ENGINE SHIPPED FROM FACTORY WITHOUT OIL. YOU MUST ADD ENGINE OIL BEFORE STARTING
ENGINE
CHECK TILLER TRANSMISSION GREASE
IMPORTANT
TILLER TRANSMISSION SHIPPED FROM FACTORY WITH THE PROPER AMOUNT OF LIQUID GREASE.
WHEN REPLACING GREASE, THE TILLER TRANSMISSION HOLDS 18-22 OUNCES. DO NOT OVERFILL
Check the grease level annually. To check the grease level:
1. Move tiller to level ground.
2. Remove grease level dipstick located between the handlebar
mounts on the engine mount. If the grease level couldn't
touch the dipstick, pls fill the grease.
3. Replace grease level dipstick in the filler hole.
4. Note that the front wheel transmission and rear tine
transmission are one common reservoir. When you add to the
front transmission, you must wait a short period of time for
the grease to flow rearward and equalize in both front and
rear. The dipstick will read correctly on level ground for both
gear units.
CHECK TIRE PRESSURE
Recommended tire pressure is 20 PSI. If tires do not have equal pressure, tiller will pull to one side.
LUBRICATION
Proper lubrication of moving mechanical parts is critical for proper care and maintenance.
Oil the moving parts shown at 10 hour intervals using a 30 weight oil.
CLEAN TINE AXLE SHAFT
1. Turn off engine. Engine must be cool.
2. Remove spark plug wire and secure from spark plug.
3. Tip the tiller forward. Block the tiller in position so that it rests on the engine mount and the tines are
exposed.
4. Remove all vegetation, string, wire, and other material that may have accumulated on the axle between
the inside set of tines and the seal on the transmission housing.
5. Tip the tiller back to a level position.
6. Replace spark plug wire.
16
BE-BRTXXX USER MANUAL
CHECK OR FILL ENGINE CRANKCASE
1. Add oil according to engine manual. Do
not overfill. Use a clean, high quality
detergent oil. Do not mix oil with gasoline.
Oil level must be full. check the oil level by
removing oil fill plug. Oil level should be up
to the bottom of the fill plug opening.
2. Always check oil level before starting engine. Refer to engine manual for capacity and
type of oil to use.
CHECK TILLER TRANSMISSION GREASE
Check the grease level annually. To check
the grease level:
1. Move tiller to level ground.
2. Remove grease level dipstick located
between the handlebar mounts on the
engine mount. If the grease level couldn't
touch the dipstick, pls fill the grease.
3. Replace grease level dipstick in the filler
hole.
4. Note that the front wheel transmission and
rear tine transmission are one common
Publicité
