Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
The rototiller comes fully assembled except for a few parts.
The following instructions will help you assemble and adjust
the tiller's depth regulator, cable tension, and handlebar
height. You will
need two 9/16" wrenches to complete the assembly.
STEP 1 Install the Depth Regulator
1. Install the depth regulator into the top of the depth
regulator Bracket with handle facing rearward.
2. Insert depth regulator pin through depth regulator
bracket and top hole of depth regulator-tines should
clear the ground.
STEP 2 Attach ex-arm-rest stems to the Tiller
1. The ex-arm-rest stems on outside of the Transmission
cover and align the lower boles.
2. Insert one 3/8"-16x 1" bolt for each side in lower holes.
3. Start 3/8"-l6 nuts on each bolt.
4. Insert one 3/8"-16x 1" bolt for each side in Upper holes at
desired handlebar height.
5. Tighten all the nuts.
ASSEMBLY INSTRUCTIONS
The rototiller comes fully assembled
except for a few parts. The following
instructions will help you assemble and
adjust the tiller's depth regulator, cable
tension, and handlebar height. You will
need two 9/16" wrenches to complete
the assembly.
STEP 1 Install the Depth Regulator
1. Install the depth regulator into the top of the depth regulator Bracket with handle facing
rearward.
2. Insert depth regulator pin through depth regulator bracket and top hole of depth
regulator-tines should clear the ground.
STEP 2 Attach ex-arm-rest stems to the Tiller
1. The ex-arm-rest stems on outside of the Transmission cover and align the
2. Insert one 3/8"-16x 1" bolt for each side in lower holes.
3. Start 3/8"-l6 nuts on each bolt.
4. Insert one 3/8"-16x 1" bolt for each side in Upper holes at desired handle
5. Tighten all the nuts.
STEP 2 Attach ex-arm-rest stems to the Tiller
1. The ex-arm-rest stems on outside of the Transmission cover and align the
2. Insert one 3/8"-16x 1" bolt for each side in lower holes.
3. Start 3/8"-l6 nuts on each bolt.
4. Insert one 3/8"-16x 1" bolt for each side in Upper holes at desired handleba
5. Tighten all the nuts.
BE-BRTXXX USER MANUAL
7
Publicité
