BE Ag & Industrial BE-BRT Serie Manuel D'utilisation Et De Pièces page 8

STEP 3: Attach handle bar to the Tiller
1. Insert four fastness bolts for each side in every holes.
2. Start fastness nuts on each bolt.
3. Tighten all the nuts.
STEP 4: Fill Engine Crankcase
IMPORTANT
Engine is shipped from factory without oil. Engine oil must
be added before starting engine.
1. Add oil according to engine manual. Do not overfill. Use
clean, high quality detergent oils. Do not mix oil with
gasoline. Oil level must be full. Check the oil level by
removing oil fill plug.
2. Always check oil level before starting engine. Refer to
engine manual for capacity and type of oil to use.
OPERATION
PRE-START INSPECTION
1. Make sure all safety guards are in place and all nuts and bolts are secure.
2. Check oil level in engine crankcase. See your engine manual for procedure and specifications.
3. Inspect air cleaner for cleanliness. See your engine manual for procedure.
4. Check the fuel supply. Fill the fuel tank no closer than 1 inch from top of tank to provide space for
expansion. See your engine manual for fuel recommendations.
5. Be sure spark plug wire is attached and spark plug is tightened securely.
6. Check position of wheels and wheel lockouts.
7. Check depth regulator lever position.
8. Examine underneath and around engine for signs of oil or fuel leaks.
9. Inspect fuel hoses for tightness and fuel.
10. Look for signs of engine damage.
11. Remove excessive debris from muffler area and recoil starter.
8
BE-BRTXXX USER MANUAL
3. Tighten all the nuts.
STEP4 Fill Engine Crankcase
IMPORTANT
Engine is shipped from factory without oil. Engine oil must be added before st
engine.
1. Add oil according to engine manual. Do not overfill. Use clean, high quality
oils. Do not mix oil with gasoline. Oil level must be full. Check the oil level by r
fill plug.
2. Always check oil level before starting engine. Refer to engine manual for c
type of oil to use.
STEP4 Fill Engine Crankcase
IMPORTANT
Engine is shipped from factory without oil. Engine oil must be added before s
engine.
1. Add oil according to engine manual. Do not overfill. Use clean, high quality
oils. Do not mix oil with gasoline. Oil level must be full. Check the oil level by
fill plug.
2. Always check oil level before starting engine. Refer to engine manual for
type of oil to use.