Télécharger Imprimer la page

Westinghouse iGen2550 Manuel De L'utilisateur page 12

Generateur d'onduleur numerique

Publicité

Les langues disponibles

Les langues disponibles

COMPONENTS
MUFFLER AND SPARK ARRESTOR
The spark arrestor prevents sparks from exiting the muffler.
It must be removed for servicing.
NOTICE
The spark arrestor is a safety device
that prevents sparks from exiting the muffler and cre-
ating a fire hazard. In certain locations a spark arrestor
may be required by law. It is the operator's responsi-
bility to know and follow all local laws and regulations
related to fire prevention requirements.
OIL DIPSTICK
Unscrew the oil dipstick to check oil levels and add oil when
needed.
OUTPUT READY LED
Illuminates when the generator is operating normally. In-
dicates the generator is producing electrical power at the
receptacles.
OVERLOAD LED
Indicates that the generator is overloaded.
OVERLOAD RESET
The generator will automatically switch OFF all AC output
to protect the generator if overloaded or if there is a short
circuit in a connected appliance.
PANEL LIGHTS ON/OFF BUTTON
Depress this button to turn the lights on both sides of the
panel on and off.
PARALLEL OPERATION OUTLETS
A parallel cord (not included) can be used to connect a
compatible Westinghouse inverter generator for additional
power output.
RECOIL HANDLE
Use the recoil handle (and the engine/fuel control switch)
to start the generator.
SPARK PLUG SERVICE DOOR
Lift the spark plug service door to access the spark plug.
USB PORTS
Two-port 5V/2.1A USB outlet. Accepts Type A USB plugs.
VENTED FUEL CAP
The fuel cap has a vent that can be opened and closed.
The vent should be open when the engine is running and
closed when the engine is off.
12 | English
FIG. 6
A
N
K
L
M
A - 120 Volt AC 20 Amp Receptacles
B - 120 Volt AC 30 Amp Receptacle
C - Parallel Operation Outlets
D - ECO Mode Switch
E - Reset Button
F - 20 Amp Circuit Breaker
G - USB Ports
H - Panel Lights On/Off Button
I - 30 Amp Circuit Breaker
J - Ground Terminal
K - Low Oil LED
L - Overload LED
M - Output Ready LED
N - Data Center
O - Service Generator LED (iGen2550c only)
P - Automatic Shutoff LED (iGen2550c only)
C
B
D
J
I
H
O
E
F
G
P

Publicité

loading

Ce manuel est également adapté pour:

Igen2550c