Scheppach KS1200 Traduction Des Instructions D'origine page 22

ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
4. Intended use
The sharpening station is suitable for sharpening saw
chains.
The machine is to be used only for its prescribed pur-
pose. Any other use is deemed to be a case of misuse.
The user / operator and not the manufacturer will be
liable for any damage or injuries of any kind caused
as a result of this.
Please note that our equipment has not been designed
for use in commercial, trade or industrial applications.
Our warranty will be voided if the machine is used
in commercial, trade or industrial businesses or for
equivalent purposes.
5. Safety instructions
General safety instructions for electric tools
m WARNING: Read all safety warnings, instruc-
tions, illustrations and technical data provided
with this power tool.
Failure to observe the following information and in-
structions can result in electric shock, fire and/or se-
rious injuries.
Store all safety instructions and information for
future reference.
The term "electric tool" used in the safety instructions
refers to mains-powered electric tools (with a mains ca-
ble) or battery-powered electric tools (without a mains
cable).
1) Work area safety
a) Keep your work area clean and well-lit. Disor-
ganised or unlit work areas can result in accidents.
b) Do not work with the electric tool in an explo-
sive environment where flammable liquids,
gases or dusts may be located. Electric tools
produce sparks that may ignite dust or vapours.
c) Keep children and other people away while us-
ing the electric tool. Distractions may cause you
to lose control of the electric tool.
22 | GB
2) Electrical safety
a) The electrical tool's connection plug must fit
into the socket.
The plug may not be modified in any way. Do
not use an adaptor plug together with earthed
electric tools. Unmodified plugs and suitable
sockets reduce the risk of an electric shock.
b) Avoid body contact with earthed surfaces,
such as pipes, heaters, ovens and refrigera-
tors. There is an increased risk of electric shock if
your body is earthed.
c) Keep electric tools away from rain and moisture.
Water entering an electric tool increases the risk of
an electric shock.
d) Do not use the connection cable for another
purpose, for example, carrying or hanging the
electric tool or pulling the plug out of the sock-
et. Keep the connection cable away from heat,
oil, sharp edges or moving parts.
Damaged or coiled connection cables increase
the risk of an electric shock.
e) If you work with an electric tool outdoors, only
use extension leads that are also suitable for
outdoor use. Using an extension lead suitable for
outdoor use reduces the risk of an electric shock.
f) If you cannot avoid using the electric tool in a
wet environment, use a residual current circuit
breaker. Using a fault-current circuit breaker re-
duces the risk of an electric shock.
3) Personal safety
a) Remain attentive, pay attention to what you are
doing and be sensible when working with elec-
tric tools. Do not use an electric tool if you are
tired or under the influence of drugs, alcohol
or medication. A moment of carelessness when
using electric tools can result in serious injuries.
b) Wear personal protective equipment and al-
ways wear safety goggles. Wearing personal
protective equipment, such as dust masks, an-
ti-slip safety shoes, safety helmet or hearing pro-
tection, depending on the type and use of the elec-
tric tool, reduces the risk of injuries.
www.scheppach.com