Sentiotec O-A1-9 Mode D'emploi page 26

Installation instructions, only for experts
4.1. Installing the sauna control unit
Refer to Fig. 1 (page 9).
1. Press the clip lock 6 in lightly using a screwdriver and remove the cover
from the housing.
2. Screw one cross-head screw (20 mm) into the wall of the sauna at a height
of approx. 1.70 m to a distance of up to 7 mm.
3. Fasten the sauna control unit onto the cross-head screw using the attach-
ment device b as an aid.
4. Guide the wires for the heater sensor through the cable bushing 4.
5. Guide the heater, power supply and light cables through the respective
cable bushing 7.
6. Screw two cross-head screws (20 mm) into the lower fastening holes 3
and 8.
7. Ensure that the sauna control unit is fitted securely.
4.2. Connecting wires
Refer to Fig. 1 (page 9) and Fig. 3 (page 13).
1. Connect the white wire for the sensor heater to terminal F1 on the terminal
strip 2; it is not necessary to ensure correct polarity here.
2. Connect the red wire for the sensor heater to terminal TS on the terminal
strip 2; it is not necessary to ensure correct polarity here.
3. Connect the heater, power supply and light cables (Fig. 3) to the terminal
strip 9 in accordance with the connection diagram.
4. Connect all available earth conductors on the earth conductor panel 5.
5. Place the cover of the housing on the upper edge of the housing base and
turn the cover of the housing downwards until it engages audibly.
WORLD OF WELLNESS
p. 8/18