Publicité
Les langues disponibles
Les langues disponibles
Instructions for installation and use
2. Important information for your safety
The sauna control unit A1 has been produced in accordance with the
applicable safety regulations for technical units. However, hazards
may occur during use. You should therefore adhere to the following
safety information and the specific warning notices in the individual
chapters.
2.1. Intended use
The sauna control unit A1 is used for operating and controlling sauna
heaters in a private household in accordance with the technical data.
It may only be used for operating and controlling 3 heating circuits
with a maximum heating capacity of 3 kW per heating circuit.
Any use exceeding this scope is considered improper use. Improper
use can result in damage to the product, severe injuries or death.
2.2. Safety information for the installer
● Installation may only be performed by a qualified electrician or
similarly qualified person.
● Installing and connecting the sauna control unit may only be
performed when the power supply is disconnected.
● An all-pole disconnecting device with full cut-off must be fitted
on-site in accordance with overvoltage category III.
● The sauna control unit must be installed outside the sauna room
at a height of approx. 1.70 m or in accordance with the recom-
mendation issued by the sauna manufacturer. The ambient
temperature must be within a range spanning -10 °C to +40 °C.
● The heater sensor must be attached in a way that it is not af-
fected by a flow of air.
WORLD OF WELLNESS
p. 4/18
Publicité
