Parkside PWS 115 B2 Traduction Des Instructions D'origine page 38

GB MT
Trial run:
Always carry out a trial run without a load
before­carrying­out­your­fi ­ rst­procedure­
as well as after every tool change. Switch
the device off immediately if the tool is not
rotating smoothly, if considerable vibration
occurs, or if you hear abnormal noises.
Continuous operation
1.­ Turn­on­the­device.
Switching on continuous opera-
tion:
2. Push the front of the on/off switch (3)
towards the device in the on position.
The­on/off­switch­makes­an­audible­
click.
Switching off continuous ope-
ration:
3. Press the back of the on/off switch (3)
briefl ­ y­once.­The­on/off­switch­will­
spring­back­into­its­initial­position.­The­
device turns off.
Cleaning and servicing
Pull the mains plug before any ad-
justments, maintenance or repair.
Have any work on the device
that is not described in this
instruction guide performed
by a professional. Only use
original parts. Allow the de-
vice to cool off before any
maintenance or cleaning is
undertaken. There is a risk of
burning!
Always check the device before using it for
obvious­defi ­ ciencies­such­as­loose,­worn­
or damaged parts, correct the positioning
of screws or other parts. Examine the
38
grinding disc in particular. Exchange the
damaged parts.
Cleaning
Do not use any cleaning agent or
solvent. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
•­ Thoroughly­clean­the­device­after­every­
use.
• Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.
Storage
• Store the appliance in a dry place well
out of reach of children.
• Grinding discs must be dry and stored
upright and should never be stacked.
Waste disposal
and environmental
protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling­centre­when­you­have­fi ­ nished­with­
them.
Electrical machines do not belong
with domestic waste.
In accordance with the Directive
2012/19/EU on waste electrical and elec-
tronic equipment, used electrical devices
must be collected separately for disposal
and recycled in an environmentally sound
manner.