Parkside PWS 115 B2 Traduction Des Instructions D'origine page 25

Intended purpose
The­angle­grinder­is­a­tool­for­cutting,­grin-
ding, scrubbing and brushing metal, con-
crete­or­tiles­without­using­water.­This­tool­
is intended for use with a wire brush.
The­device­is­not­intended­for­any­other­
types of applications (e.g. grinding with
unsuitable grinding tools, grinding with a
coolant solution, grinding or cutting hazar-
dous materials such as asbestos).
The­device­is­intended­to­be­used­by­do-it-
yourselfers. It was not designed for heavy
commercial­use.­The­tool­is­to­be­used­by­
adults. Children over the age of 16 may
not use the tool except under supervision.
The­manufacturer­is­not­liable­for­damages­
caused by an improper use or incorrect
operation of this device.
General description
­The­illustration­of­the­principal­
functioning parts can be found
on the front and back foldout
pages.
Extent of the delivery
Carefully unpack the appliance and check
that it is complete:
- Device
- Handgrip
- Protective hood
- Chuck key
- Instructions for use
Cutting disc/grinding wheel/grin-
ding disc/wire brush not included
in delivery. For accessories, ple-
ase refer to the chapter "Spare
parts/accessories".
Description of function
The­angle­grinder­is­made­for­cutting,­grin-
ding,­scrubbing­or­brushing­metal.­There­is­
a special disc for each of the separate ap-
plications. Please refer to the information
from the disc manufacturer.
Please refer to the descriptions below for
information about the operating devices.
Overview
1 Handgrip
­ 2­ Threads­for­handgrip
3 On/off switch
4 Protective hood
4.1 Attachment, protective cover
5 Grinding disc
6 Spindle stop button
7 Power plug
8 Chuck key
­ 9­ Mounting­fl ­ ange
10 Clamping nut
11 Mounting spindle
12 Grid
13 Notch
Technical data
Angle grinder.............. PWS 115 B2
Rated input voltage (U) ..... 230 V~, 50 Hz
Power input (P) .............................750 W
Idling speed (n) .................... 12000 min
Cutting / roughing / grinding discs
Outside diameter .........max. Ø 115 mm
Bore hole ............................ 22.23 mm
Thickness ........................... max. 6 mm
Spindle thread .................................M14
Thread­length ...................... max. 12 mm
Safety class .....................................
Protection category ..........................IPX0
Sound pressure level
(L ) ...................... 89 dB(A); K
pA
GB MT
-1
II
= 3 dB
pA
25