Parkside PWS 115 B2 Traduction Des Instructions D'origine page 32

GB MT
Other special safety
instructions for cutting
grinding
a) Avoid blocking the cutting disc
or pressing down too hard. Do
not make any excessively deep
cuts. Overloading the cutting disc
increases wear and its tendency to tilt
or block and, with that, to kickback or
break the grinder.
b) Avoid the area in front of and
behind the rotating cutting disc.
When you move the cutting disc by itself
in the workpiece, in the event that the
electric tool kicks back with the rotating
disc, it can spin directly towards you.
c) If the cutting disc jams, or you
interrupt your work, switch the
device off and hold it until the
disc has come to a full stop. Ne-
ver try to pull the cutting disc
out of the cut while it is still run-
ning, because it can kick back.
Identify and correct the cause of the
jamming.
d) Do not switch the electric tool
on again as long as it is in the
workpiece. Allow the cutting
disc to fi rst reach its full rotatio­
nal speed before you carefully
resume with the cutting. Other-
wise, the disc may catch, spring away
from the workpiece or cause a kick-
back.
e) Support plates or workpieces to
reduce the risk of kickback from
a jammed cutting disc. Large
workpieces may bend under
their own weight.­The­workpiece­
must be supported on both sides of the
disc, near the cutting disc as well as
also at the edge.
f) Be particularly careful for po-
32
cket cuts in existing walls or
other areas where you cannot
see what is there.­The­cutting­disc­
may cause a kickback when it cuts into
gas or water lines, electrical lines or
other hidden objects.
Additional safety
instructions for working
with wire brushes
Special safety instructions for
working with wire brushes:
• Be aware that the wire brushes
also lose wire pieces during typi-
cal use. Do not overload the wi-
res by pressing down too hard.
Flying wire pieces can very easily penet-
rate thin clothing and/or your skin.
• If a protective hood is recom-
mended, do not allow the wire
brushes and the protective hood
to touch each other. The­diameter­
of plate and cup brushes can enlarge if
too much pressure and centrifugal force
is exerted.
Additional safety
instructions
• Connect the appliance only to a power
socket with a residual current circuit
breaker of rated residual current no
more than 30 mA.
• Keep power cords and extension cords
away from the disc. If they are dama-
ged or cut through, immediately pull
the plug from the outlet. Do not touch
the cable before it has been discon-
nected from the power supply. Risk of
electric­shock!
• If the power tool's mains connection
cable is damaged, it must be replaced