Publicité
Les langues disponibles
Les langues disponibles
ID 300 T DC PULSE / ID 300 TW DC PULSE
3.2 TIG Cycle
Initial
Pre-Gas
Current
The statuses of the functions on or off according to the modes are as follows.
3.3 Menu Structure
Parameter
Pre-Gas Flow Time
Start Current
Up-Slope Time
Main Current
Base Current
Pulse Cycle Rate
Frequency
Down-Slope Time
Final Current
Post-Gas Flow Time
Spot Welding Time
Water Cooler Time
3.3.1 TIG Welding Process
In HF Start TIG mode, a high ignition voltage is present at the torch. Never touch the tungsten
• 10 jobs programs including complete parameter settings can be stored and run for repeated jobs.
electrode or parts conducting welding current when the device is switched on.
• In the first use, all parameters of all programs are in factory settings which are shown in the table.
• Push the program selection button. For selecting a previously adjusted program or changing its parameters.
• Push the welding mode selection button for selecting Touch-Lift TIG of HF start TIG.
• Push the 2 Stroke - 4 Stroke - Spot Welding Selection Button for selecting the appropriate mode for the work.
• Use TIG parameter selection button (13-14) to change the welding parameters.When the led, which belongs
to the parameter you will change is turned on,adjust the parameter by turning the parameter adjustment
button.
• Latest adjusted parameter values will be saved automatically. There is no need to do anything else for saving
the settings.
www.magmaweld.com
** Spot Welding Time
Start Ramp
ID 300 T DC PULSE
Factory Setting
ID 300 TW DC PULSE
0-10 sec.
5 - 300 A
0.1-10 sec.
5 - 300 A
5 - 300 A
%1 - %99
0.1 - 2000 Hz
0.1 - 10 sec.
5 - 300 A
0-20 sec.
0-20 sec.
1 - 20
Pulse
Frequency
(Width)
Pulse
Lower
End Ramp
Current
LED
MMA Welding
0 - 5 sec.
18
30 A
19
1 sec.
20
85 A
21
40 A
22
% 50
23
75 Hz
24
1 sec.
25
30 A
26
0.1 sec.
27
2 sec.
28
3 min.
Operation
23
Final
Final Gas
Current
USER MANUAL
EN
Publicité
