Magmaweld ID 300 T DC PULSE Mode D'emploi page 21

ID 300 T DC PULSE / ID 300 TW DC PULSE
OPERATION
3.1 User Interface
It is used to set the welding parameters to the desired value.
Parameter Adjustment Pot
1
It shows the numerical value of the selected welding parameter and the current value during welding.
Digital Display
It also shows error message in case of error.
2
It is used to select one of 10 work programs covering all parameter settings in TIG modes. Thanks to
Program Selection Button
the programs, the adjusted parameters are kept in the memory of the machine and can be used for
repetitive jobs, selected by the user. The last settings made for the selected program number will be
saved automatically, no further action is required for recording. In addition, while still in TIG modes,
3
it allows to switch to the cooling time setting when pressed for 3 seconds.
Shows the program number selected with the program selection button. It also shows the letter C
Digital Program Display
when setting the cooling time.
4
It is used to select one of the MMA welding, HF ignition TIG welding and Touch Start TIG welding
Welding Mode Selector Button
modes.
6 Led lights up when MMA welding mode is selected.
7 Led lights up when HF ignition TIG welding mode is selected. In this mode, when the electrode is
approached without touching the workpiece, the arc starts with a voltage jump over the gas.
5
8 Led lights up when Touch Start TIG welding mode is selected. In this mode, arc starts when the
electrode touches the workpiece and is pulled.
www.magmaweld.com
Operation 21
EN
USER MANUAL