Publicité
Les langues disponibles
Les langues disponibles
20
Installation
2.6 Connections for (MMA) Welding
EN
Check for the correct mains voltage before connecting the machine to the mains.
When plugging the power plug into the outlet, make sure that the power switch is set to "0"
• Start the machine with the on/off switch and check whether the leds are on and the cooling fan is working.
in the turned-off position.
• Connect the electrode clamp cable plug (c) and the grounding clamp cable plug (a) to the welding and ground
cable sockets according to the electrode to be used and the polarity recommended by the electrode manufacturer.
• To improve the welding quality, firmly connect the grounding pliers (b) to the workpiece as close as possible to
the welding area.
b
2.7 Water Cooling Unit (for Water Cooled Models)
• Unit The water cooling unit is used to cool the torch It is a closed circuit system consisting of radiator, fan, pump
coolant reservoir.
• Connect the cold (blue) water hose to the cold water outlet on the water cooling system, and the hot (red) water
If your machine has a water cooling unit;
hose to the hot water inlet on the water cooling system.
• Magmaweld welding machines come with Magmaweld coolant, which is produced to give the best performance.
In case of lack of coolant, open the coolant reservoir cap and add Magmaweld coolant suitable for the
temperature of the working environment. The coolant must be within the minimum and maximum values
shown on the front panel of the unit.
• Different coolant or water should not be added. Different liquid additives can cause chemical reactions or
different problems.
• Magmaweld is not responsible for the risks that may arise in case of adding different liquids. All warranty
provisions will be void if different coolant or water is added to the Magmaweld coolant.
• If it is desired to use a different brand of coolant, the inside of the coolant tank should be completely empty and
there should be no residue or liquid in it.
• It is not suitable to use the water-cooling units with welding machines other than manufactured by Magma
Mekatronik Makine ve Sanayi Ticaret A.Ş. Water cooling units cannot be operated with external supply.
USER MANUAL
Covered
2.0
"mm"
2.5
3.25
4.0
c
a
ID 300 T DC PULSE / ID 300 TW DC PULSE
Rutile
Alkaline
Recommended Welding Current
40-60 A
-
60-90 A
60-90 A
100-140 A
100-130 A
140-180 A
140-180 A
Cellulosic
-
60-100 A
70-130 A
120-170 A
www.magmaweld.com
Publicité
