Energizer eZG7250 Guide De L'utilisateur page 23

4.2 Using the EZG7250 with your Appliances
After starting the eZG7250 you can connect your devices to it. If you want to use the
120V outlets, be sure to move the "Voltage Switch" is in the right position.
Before starting make sure that you know what you are able to power with your Genera-
tor. Here's how you can decide:
Add the watt ratings of all the loads that the generator set will be powering at the same
time. Make sure that total wattage will not exceed the generator rating.
EXAMPLE:
A generator set rated 5000W can power two 1500W heaters, a 900W circular saw, a
500W drill and a 100W light at the same time (4500W combined). However, to operate
a second 900W saw, it will be necessary to disconnect one of the 1500 W heaters.
To stop the engine in an emergency, turn the engine switch "OFF". Always
connect the generator to the ground terminal to prevent electrical shock.
1. Turn off the switches of devices before
before connecting them to your generator.
2. Insert the plug of the device into your generator
based on its voltage requirements. Your eZG7250
generator includes two (2) 120V AC outlets and one
(1) 120/240V AC outlet for power specific appliances
such as an oven or washer/dryer.
Be sure the "Voltage Switch" is appointed to
the outlet type that you require.
3. You can now turn your devices on and use them.
23
series