Energizer eZG7250 Guide De L'utilisateur page 14

2.3 Mounting Instructions for eZG7250 (Refer to Figure Below)
1. Attach the handle bars to the middle of the generator frame where
specified in the figure below. Tighten the bolts (14) and nuts (7) to the upper
frame of the generator.
2. Attach the two peg stands at the bottom of the frame of the genera-
tor. Tighten the two bolts (6) and two nuts (7) to the lower frame of the
generator.
3. Place the two wheels (5) on the wheel axle (4) and then secure the washer
(8) using the split pin (9) to the wheel axle (4).
4. Attach the wheel axle (4) to the bottom of the generator frame. Align the
bolts (6) with the holes on the bottom of the generator and fasten tightly
with the nuts (7) provided.
14