Eaton Tripp Lite Serie Mode D'emploi page 19

Table 3. CLI Commands
User Command Name
login login to the shell
logout logout of the shell
set_new_password Set a new password
set_ipv4_maskaddr Set the subnet mask
address
get_ipv4_maskaddr Get the assigned subnet
mask address
set_ipv4_addr Set the assigned IP
address
get_ipv4_addr Get the assigned IP
address
set_ipv4_gateway Set the IP gateway
get_ipv4_gateway Get the IP gateway
get_ipv4_method Get the IP method
set_ipv4_method_dhcp Set DHCP IP
get_mac_addr Get MAC Address
get_proxy_addr Get the assigned proxy
address
set_proxy_addr Set the proxy address
get_proxy_port
Get the port
set_proxy_port
Set the port
Description Sample Input/Output
<password>
N/A
"Pa$sw0rd"
255.255.255.0
255.255.255.0
192.168.0.133
192.168.0.133
192.168.0.1
192.168.0.1
IP Method set as static/
DHCP.
IP Method set as DHCP
00:00:00:00:00:00
PROXY Address is -
proxy.apac.etn.com
Proxy address
reconfigured
successfully.
PROXY port is - 8080
Proxy port number
reconfigured
successfully.
Eaton Tripp Lite Series Cloud Connected UPS Systems User Guide 934859—Rev C
Command Line Interface
Note
Only used for entering to shell It gets the
current password as input
This command prompt you to login after logout
The default value is "password". New
Password has following limits:
1. The length must be at least 8 and max 16
characters.
2. The string is alphanumeric case
sensitive.
3. The new password must at least have
one digit, one upper case, one lower
case, and one special case characters.
4. The previous password is required to
enter.
5. The new password must be entered
twice.
This value will initialize as "0.0.0.0" if the
device is not connected to the internet. The
default restore IP address is "192.168.1.254".
The default value is DHCP.
The length must be less than 20 characters
Any range between 0-65535
13