Eaton Tripp Lite Serie Mode D'emploi page 55

Figure 59. Add and Configure Device
6. Click on Configure Device(s) with NFC.
7. Click on + Add New Configuration Profile.
8. Enter in a Configuration Profile Name.
9. Select the IPv4 Method, DHCP (Automatic) or Static.
NOTE If the IPv4 method selected is Static then the subnet mask and default gateway address
must be entered.
10. Set the Proxy IP address and the Proxy Port number.
NOTE An additional proxy user name and password may be required.
Eaton Tripp Lite Series Cloud Connected UPS Systems User Guide 934859—Rev C
Adding a Device
49