Eaton Tripp Lite Serie Mode D'emploi page 16

Turning the UPS Off
• To enable the alarm tone in Battery Mode, press and hold the power button for five seconds. The green
LED will flash and the UPS alarm tone will sound, indicating that the alarm has been enabled.
NOTE
3 3 . . 5 5 T T u u r r n n i i n n g g t t h h e e U U P P S S O O f f f f
To turn off the UPS, press and hold the ON/OFF button on the front panel for two seconds, the UPS will beep
indicating it is in Standby Mode. Unplug the UPS from the power source. If you do not unplug the UPS, it
remains in Standby Mode.
3 3 . . 6 6 L L E E D D I I n n d d i i c c a a t t o o r r s s
The Tripp Lite Series UPS system rear panel indicates the UPS status via the UPS LED indicators.
shows the LED status and operational mode of the UPS.
Table 2. LED Status
Green (Flashing every ten seconds)
Green (Flashing) Red (On)
Green (Flashing On for five seconds/Off
10 Eaton Tripp Lite Series Cloud Connected UPS Systems User Guide 934859—Rev C
To verify the alarm status, test the UPS on battery power.
LED Status
Green (On)
Green (Off)
Red (On)
for five seconds)
Alarm
Off
Off
Sounding every second
Off
Continuously sounding
Off
Table 2
UPS Status
Operating in normal line mode and the
battery is fully charged
Operating in battery mode
Low battery
UPS is off
UPS fault (See Table 6)
Operating in normal line mode and
charging the battery