Publicité
Les langues disponibles
Les langues disponibles
Installation Continued
3. Mounting the Faucet
A. Apply 3-5 wraps of plumber tape to faucet stem.
B. Assemble faucet as shown in (Figure 3).
C. Screw quick connector onto threaded end of faucet stem.
D. Place a mark 5/8" from one end of the blue tubing. Wet the end
of the 3/8" tube and push into bottom of connector. The 5/8"
mark should be flush with the collar of the connector.
NOTE: To remove the tube, push on the fittings' collar and pull the
tube out.
E. Holding the faucet, feed the tubing through the hole in the sink.
Position the faucet handle at a desired location.
F. Center the faucet and slip slotted disc between the bottom of
the counter or sink and lock washer. Tighten the stem nut with a
wrench until it is tight.
G. Firmly insert spout into faucet base.
4. Mounting the System
A. Select a location under the sink, or other suitable area where the
system will be installed.
NOTE: The system carton can be used to determine the operational
footprint required for installation of the system and replacement
cartridges. (Figure 4a)
B. Mount the system vertically. Dimensions in the diagram allow for
cartridge or system removal. Ensure mounting is level. Use the
3/32" drill bit to create pilot holes for the mounting (Figure 4b).
WARNING: The system should be mounted to a firm, solid surface
that is able to support the weight of the system.
4b
2 3/8"
(60.3 mm)
3
Faucet Stem
Chrome
Plate
Rubber
Washer
Counter Top
Slotted
Disk
Lock Washer
Stem Nut
Quick
Connector
3/8" Tubing
4a
13.5" (343 mm)
FRESHPOINT F1000-DFB, F1000-B1B Filtration Systems Instruction Manual • 5
7" (178 mm)
Inlet
7.875" (200 mm)
Outlet
Publicité
