Publicité
Les langues disponibles
Les langues disponibles
Installation
NOTE:
• For standard under-sink installation on 1/2" 14 NPS threads or
3/8" x 3/8" compression
• Please read all instructions and precautions before installing
and using your Filtration System
• Numbered diagrams correspond with numbered steps
1. Installing the Water Supply Adapter
The supply adapter fits 1/2"-14 NPS supply threads or 3/8" x 3/8"
compression. If local codes permit, it may be used to connect the
system to the cold water supply line. If local codes do not permit
the use of the supply adapter, alternate connectors can be obtained
from your local supplier.
A. Turn off cold water supply line. If cold water line does not have a
shut-off valve under the sink, you should install one.
B. Turn on the cold water faucet and allow all water to drain
from line.
C. Disconnect riser cold water supply valve.
D. Ensure the sealing gasket is fully seated into the feed adapter
valve female thread.
E. Install feed adapter valve onto supply valve. Hand tighten only.
F. Connect the riser to the feed adapter valve.
NOTE: See Figures 1G-1H for configuring the feed adapter to
3/8" x 3/8" compression connections.
2. Selecting the Faucet Location
NOTE: The drinking water faucet should be positioned with
function, convenience, and appearance in mind. An adequate flat
area is required to allow faucet base to rest securely. The faucet
fits through a 3/4" hole. Most sinks have pre-drilled 1-3⁄8" or 1-1⁄2"
diameter holes that may be used for faucet installation. If these
pre-drilled holes cannot be used or are in an inconvenient location,
it will be necessary to drill a 3/4" hole in the sink to accommodate
the faucet.
CAUTION: This procedure may generate dust which can cause
severe irritation if inhaled or come in contact with the eyes. The use
of safety glasses and respirator for this procedure is recommended.
CAUTION: DO NOT ATTEMPT TO DRILL THROUGH AN ALL-
PORCELAIN SINK. If you have an all-porcelain sink, mount the
faucet in pre-drilled sprayer hole or drill through countertop next to
sink.
CAUTION: When drilling through a countertop, make sure the area
below the drilled area is free of wiring and piping. Make certain you
have ample room to make the proper connections to the bottom of
the faucet.
CAUTION: Do not drill through a countertop that is more than 1"
thick.
CAUTION: Do not attempt to drill through a tiled, marble, granite
or similar countertop. Consult a plumber or the countertop
manufacturer for advice or assistance.
A. Line bottom of sink with newspaper to prevent metal shavings,
parts, or tools from falling down the drain.
B. Place masking tape over the area to be drilled to prevent
scratches if drill bit slips.
C. Mark hole with center punch. Use a 1/4" drill bit to drill pilot hole.
D. Use a 3/4" drill bit and drill a hole completely through sink.
E. Smooth rough edges with a file.
4 • FRESHPOINT F1000-DFB, F1000-B1B Filtration Systems Instruction Manual
1A
1C
Sealing Gasket
1G
1H
2
C
D
⁄
1
4"
1
⁄
1
4"
1B
1D
Publicité
