Publicité
Les langues disponibles
Les langues disponibles
Installation and commissioning instructions
WARNING
Risk of injury due to weight of inverter.
Incorrect lifting during transport and assembly or disassembly can cause injuries. If the
inverter falls down, there is a risk of crushing limbs.
f Observe the weight of the inverter.
f Mount and disassemble the inverter with a second person.
f Use screws and, if necessary, dowels which are suitable for the assembly location and
weight.
f Wear suitable protective equipment during assembly and disassembly.
NOTE
Loss of power or damage to the inverter due to improper installation.
NOTE
Damage to the inverter.
If connections not in use are not sealed, this may influence the IP degree of protection.
f Always seal connections not in use with protective caps.
NOTE
Damage to the inverter.
Incorrectly connected components may cause damage to the inverter.
f Follow the instructions of manufacturers of the connected components.
f Only connect components according to the circuit diagram.
NOTE
Damage to the inverter and the PV module.
If the DC plugs are not connected correctly to the DC cable, there is a risk of short circuit.
f Connect counterparts to the DC connections to the DC cable ensuring correct polarity.
NOTE
The communication cables used must be shielded. CAT 5E or higher must be used for network
cables. RS485 cables that belong together must be twisted.
Z02 | 2404 | 780.767
Safety
DE
EN
EN
FR
IT
SV
NO
FI
23
Publicité
