Publicité
Les langues disponibles
Les langues disponibles
Attaching/removing a dust
extraction unit
WARNING! RISK OF EXPLOSION!
■
If there is an explosive dust/air mixture, you
must use a specially designed extraction
appliance. RISK OF FIRE DUE TO FLYING
SPARKS! Do not use dust extraction systems
(dust collector
grinding metals.
■
Materials containing asbestos must not be
processed. Asbestos is a known carcinogen.
WARNING! RISK OF FIRE!
■
When working with power tools which have
a dust collector or can be connected to a
vacuum cleaner via a vacuum cleaner adapter,
there is a risk of fire! In unfavourable condi-
tions, e.g. when sparks are flying while
sanding metal or metal residues in wood,
wood dust in the dust collector (or the bag of
the vacuum cleaner) can spontaneously
ignite. This is a particular risk if the wood dust
is mixed with paint residues or other chemi-
cals and the workpiece has become hot after
being worked for a long time. Therefore, do
not allow the workpiece to overheat and
always empty the dust box or the dust bag
of the vacuum cleaner before taking a break
from work.
■
Ensure that your workplace is adequately
ventilated.
■
Observe the regulations applicable in your
country regarding the materials to be
worked.
■
Wear a dust mask.
Fitting the dust collector
♦
Push the dust collector
connection
from above.
Dismantling/removing the dust collector
♦
Pull the dust collector
│
GB │ IE
■
6
or vacuum cleaner) when
onto the dust collector
off upwards.
Connecting a dust extraction adapter and
reducer for an external extraction appliance
♦
Push the dust extraction adapter
connection
.
♦
Push the reducer
adapter into the adapter fitting
♦
Push the hose from a suitable dust extraction
appliance (e.g. a workshop vacuum cleaner)
onto the reducer
extraction.
Removing the dust extraction adapter and
reducer for an external extraction appliance
♦
Pull off the hose of the dust extraction
appliance.
♦
Remove the reducer
extraction.
♦
Pull the dust extraction adapter
off the connection
Working procedures
■
Secure the workpiece. A workpiece held in a
clamp or vise is held more securely than with
your hand.
A light grinding pressure is sufficient
■
Apply minimal pressure when grinding. The belt
grinder's own weight is sufficient for a good
grinding result. In addition, working this way
helps to reduce the wear on the abrasive belt
and the surface of the workpiece will become
more smooth.
Removal and surface
■
The material removal rate and surface quality
are determined by the belt speed and grain
strength of the abrasive belt
section "Selecting speed and abrasive belt").
Grinding
■
Place the appliance on the workpiece when
switched on and work at a moderate feed rate.
Guide the grinder in parallel and overlapping
sanding motions over the workpiece. To avoid
unpleasant transverse grinding marks, always
sand in the direction of the grain.
After completing the task, lift the appliance from
the workpiece and then switch it off.
onto the
for the dust extraction
.
for external vacuum
for external dust
upwards
.
(see also the
PBSD 900 A2
Publicité
