Parkside 437475 2304 Traduction Des Instructions D'origine page 10

NOTE
► Always hold the appliance firmly with two
hands while working.
Use
Switching on and off
While operating the belt grinder, you can choose
between instantaneous and continuous operation.
Switching to instantaneous operation
♦ Press the ON/OFF switch
Switching off instantaneous operation
♦ Release the ON/OFF switch
Switching to continuous operation
♦ Press the ON/OFF switch
in and then press the lock button
Switching off continuous operation
♦ Press the ON/OFF switch
release it.
Emptying the dust collector
The dust collector should be emptied after every
10 minutes of operation at least.
♦ Pull the dust collector
"Attaching/removing a dust extraction unit")
♦ Shake the dust collector
bin to empty it.
♦ Fit the dust collector
appliance.
Selecting speed and abrasive belt
You can use the belt speed adjusting wheel
adjust the speed, even while the appliance is
running. The optimum belt speed is dependent on
the workpiece or material being processed. We
recommend carrying out a practice run to deter-
mine the correct speed. In the table below, you will
find some recommended values which will help you
determine which belt and speed to use for which
job.
PBSD 900 A2
.
.
, keep it pressed
.
and then
off (see section
over a rubbish
back onto the
to
Material/
working area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Material/
working area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Material/
working area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Material/
working area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Material/
working area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Softwood
60
240
high (5–6)
Hardwood
60
180
high (5–6)
Chipboard
60
150
high (5–6)
Removing
paint/varnish
60
––
high (5–6)
Rubbing down
paintwork/varnish
150
320
low (1–2)
GB │ IE │
7 ■