Publicité
Les langues disponibles
Les langues disponibles
Material/
working area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Material/
working area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Material/
working area
Rough sanding
(grain size)
Finishing (grain size)
Speed preselection
Stationary work
♦
Turn the additional handle
position.
♦
Turn the power tool as shown in the illustration
and place it on a stable worktop.
♦
Fit the two screw clamps
provided and clamp the power tool tightly.
Tips and tricks
■
Never use the same abrasive belt
wood and metal.
■
Worn or cracked abrasive belts can damage
the workpiece. Therefore, be sure to replace
worn abrasive belts before starting work.
■
Always hang up the abrasive belts to store
them, as kinks etc. can make them unusable.
│
GB │ IE
■
8
Removing
rust from steel
40
120
medium/high (3–4)
Plastics
120
240
low/medium (2–3)
Non-ferrous metals
(e.g. aluminium)
80
150
medium/high (3–4)
to the horizontal
in the recesses
to work
Maintenance and cleaning
WARNING! RISK OF INJURY!
Switch off the appliance and pull
out the power plug before starting
any work on the appliance.
The belt grinder is maintenance-free.
■
Always clean the appliance directly after
finishing work.
■
Use a dry cloth to clean the housing. Under no
circumstances should you use fuel, detergents,
solvents or abrasive cleaners.
Emptying/cleaning the dust collector
♦
Pull the dust collector
♦
Empty the dust collector
knocking out the contents and then push the
dust collector
back onto the appliance.
♦
Ensure ventilation openings are always free.
♦
Remove any adhering grinding dust with a
brush.
Disposal
Applies only to France
The product, its packaging and the operating
instructions are recyclable. They are subject to an
extended manufacturer responsibility and will be
collected separately.
off the appliance.
completely by
PBSD 900 A2
Publicité
