EINHELL TC-SP 204/2 Instructions D'origine page 23

3. The machine cuts out when planing:
•
Blunt knife or feed speed too high. Replace
the knife or reduce the feed speed.
4. Loss of speed when planing:
•
Cutting depth too deep. Reduce cutting
depth.
•
Feed speed too high. Reduce feed speed.
•
Blunt knife. Replace knife.
5. Poor surface quality on the planed work-
piece:
•
Blunt knife. Replace knife.
•
Uneven feed. Feed the workpiece at constant
pressure and reduced feed speed.
•
Dust extraction system (not supplied) not
connected. Connect dust extraction system.
6. Chip discharge for surfacing or thicknes-
sing blocked:
•
Dust extraction system (not supplied) not
connected. Connect dust extraction system.
•
Wood too wet.
7. Uneven feed speed for thicknessing:
•
Rubber belt too loose. Check rubber belt and
replace if necessary.
•
Thicknessing table (20) soiled. Clean the
thicknessing table (20) and treat with a lubri-
cant if necessary.
9. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
10. Cleaning, maintenance and
ordering of spare parts
Danger!
Pull out the power plug before performing any
maintenance, cleaning and adjusting work
10.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
Anl_TC_SP_204_2_SPK13.indb 23 Anl_TC_SP_204_2_SPK13.indb 23
GB
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
10.2 Maintenance (Figure 1/15)
Important: Pull the mains plug before starting
and maintenance work.
10.2.1 Machine
Lubricate the following parts periodically after
around 10 hours of service:
•
Bearings for the feed/discharge rollers (f) and
anti-kick claws (24)
•
Bearings on the belt roller and pulley
•
Grub screws to adjust the height of the thick-
nessing table (20)
Use only dry lubricant.
The feed table (13), planing table (14), thicknes-
sing table, feed/discharge rollers and anti-kick
claws (24) must be kept free of resin at all times.
Soiled feed/discharge rollers or anti-kick claws
(24) must be cleaned without delay.
To prevent the motor overheating, the dust that
accumulates in the ventilation openings must be
removed at regular intervals.
Improve the smooth running of the tables by ap-
plying lubricant at regular intervals.
10.2.2 Cutting tool
Resin must be cleaned off the knife (21), latch
(22) and knife block (23) at regular intervals.
Clean these components with an appropriate
resin remover.
10.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
- 23 -
15.02.2024 08:50:58 15.02.2024 08:50:58