Note: The Kiox only charges while it is switched on.
Note: If the Kiox is switched off during charging via a
USB cable, the Kiox can only be switched on again
once the USB cable has been disconnected.
Note: To maximize the service life of the on-board
computer's internal battery, it should be recharged
for one hour every three months.
Resetting Storage Mode/Kiox
The on-board computer has an energy-saving storage
mode which minimizes the rate at which the internal
battery discharges. Setting to this mode erases the
date and time.
This mode can only be activated by pressing and
holding the on/off button (4) of the on-board com-
puter (for at least eight seconds).
If the on-board computer does not start when the on/
off button (4) is pressed briefly, the on-board com-
puter is in storage mode.
You can deactivate storage mode by pressing the on/
off button (4) for at least two seconds.
The on-board computer detects whether it is in fully
working order. If you press and hold the on/off but-
ton (4) for at least eight seconds while the on-board
computer is in fully working order, it will go into stor-
age mode. If, contrary to expectations, the Kiox is not
in a fully functional condition and cannot be operated,
pressing and holding the on/off button (4) (for at
least eight seconds) will reset it. After being reset,
the on-board computer will restart automatically after
approx. five seconds. If the Kiox does not restart,
press the on/off button (4) for two seconds.
To reset the Kiox to its factory settings, select <Set-
tings> → <Sys settings> → <Factory reset>. All
user data will be lost.
Battery charge indicator of the eBike
battery
The battery charge indicator of the eBike bat-
tery d (see "Start page", page English – 17) can be
read on the status page and in the statusbar. The
eBike rechargeable battery's state of charge is also in-
Bosch eBike Systems
dicated by the LEDs on the eBike rechargeable bat-
tery itself.
Color of the indicator
Green
Orange
Red
Red + !
If the eBike battery is being charged on the eBike, a
corresponding notification will be displayed.
If the on-board computer is removed from the
holder (5), the state of charge that was last displayed
for the eBike rechargeable battery is saved.
Setting the Riding Mode
On the operating unit (7), you can set the level of as-
sistance you want the eBike drive to provide you with
while pedaling. The riding mode can be changed even
while cycling.
Note: In some models, the riding mode may be preset
and cannot be changed. There may also be fewer rid-
ing modes available than stated here.
The following riding modes are available as a maxi-
mum:
– OFF: Drive assistance is switched off. The eBike
can only be moved by pedaling, as with a normal bi-
cycle. The walk assistance cannot be activated in
this riding mode.
– ECO: Effective assistance with maximum effi-
ciency, for maximum range
English – 13
Meaning
The eBike rechargeable
battery is over 30 %
charged.
The eBike rechargeable
battery is charged be-
tween 15 % and 30 %.
The eBike rechargeable
battery is charged be-
tween 0 % and 15 %.
The capacity for assisting
the drive has been used
up, and assistance is
switched off. The remain-
ing capacity will be pro-
vided for the bike lights
and the on-board com-
puter.
1 270 U20 XBK | (11.03.2024)