Bosch Kiox BUI330 Notice D'utilisation D'origine page 13

Fitting and removing the on-board
computer (see figure A)
Fit the lower part of the Kiox into the holder (5) first
and tilt it forward gently until you can feel that the on-
board computer is firmly fixed in the magnetic holder.
To remove the on-board computer, hold it by the top
end and pull it toward you until it disengages from the
magnetic holder.
When you park up the eBike, remove the on-
u
board computer.
Before initial commissioning
Prior to initial start-up, remove the protective
u
film from the display to guarantee that the on-
board computer is fully functional. If the protec-
tive film remains on the display, this can impact the
functionality/performance of the on-board com-
puter.
Kiox is supplied with a partially charged internal bat-
tery. Before using it for the first time, this battery
must be charged for at least one hour via the USB
port or via the eBike system (see "Energy supply of
the on-board computer", page English – 12).
The operating unit should be attached such that the
buttons are almost perpendicular to the handlebars.
When using the on-board computer for the first time,
the language selection page is displayed initially. You
can then choose to have essential functions and indi-
cations explained via the <Intro to Kiox> menu item.
The menu item can also be called up at a later time
via <Settings> → <Information>.
Switching the on-board computer on/off
To switch on and switch off the on-board computer,
briefly press the on/off button (4).
Bosch eBike Systems
The on-board computer can be secured in place to
prevent it from being removed from the holder. To do
this, loosen the headset screw (16) until the Kiox
holder can be swiveled sideways. Put the on-board
computer in the holder. Screw the locking screw (M3,
6 mm long) from below into the thread provided in
the on-board computer (using a longer screw may
damage the on-board computer). Swivel the holder
back into place and tighten the headset screw in ac-
cordance with the manufacturer's specifications.
Operation
Selecting system settings
Fit the on-board computer in the holder and proceed
as follows while the eBike is stationary:
Go to the status page (use the < button (10) on the
operating unit to get to the first display) and call up
the <Settings> with the select button (9).
You can use the – (11) and + (12) buttons to select
the setting you want. You can open the settings, as
well as any additional submenus, using the select but-
ton (9). You can use the button < (10) to go back to
the previous menu from any settings menu.
The following settings can be changed in the <Sys
settings>:
– <Brightness>
– <Time>
– <Date>
– <Time zone>
– <24h format>
– <Bright background>
– <Imperial units>
– <Language>
Here, the required language can be selected from
the following options: German, English, French,
Spanish, Portuguese, Italian, Dutch, Danish,
Swedish.
– <Factory reset>
English – 11
1 270 U20 XBK | (11.03.2024)