Parkside Performance PABSP 20 Li C3 Instructions D'utilisation Et Consignes De Sécurité page 45

˜ Attaching/removing the
accessory tool
m CAUTION! RISK OF INJURY!
Accessory tools can be sharp and
may become hot during use. Always
wear protective gloves when handling
accessory tools!
m WARNING!
Always switch the product off, remove
the battery pack
product cool down before making any
adjustments!
m CAUTION! RISK OF INJURY!
Keep your hands away from the accessory
u
tool when the product is in operation.
m CAUTION! RISK OF INJURY!
After the product has been switched off, the
u
accessory tool continues moving for some
time. Do not touch the accessory tool and
do not attempt to brake it.
This product is equipped with an automatic
spindle lock to open or close the chuck
the chuck sleeve .
[ 2 ]
1. Open the chuck: Turn the chuck sleeve in a
counter-clockwise direction (Fig. E).
2. Insert a suitable accessory tool into the chuck
as deep as required.
3. Close the chuck: Hold the accessory tool in
position. Turn the chuck sleeve in a clockwise
direction.
and let the
[ ]
with
1 ] [
NOTES
This product is equipped with a Röhm drill
u
chuck with an anti-lock function.
If you attempt to open the fully opened
u
chuck further, the anti-lock function will be
activated to protect the chuck.
When the anti-lock function is activated,
u
the chuck cannot be closed by turning the
chuck sleeve in a clockwise direction. A
ratcheting sound will be produced when
you attempt to close the chuck.
Deactivating the chuck's anti-lock function:
u
Turn the chuck sleeve in a clockwise
direction by a certain extent. Then, turn
the chuck sleeve suddenly and quickly in a
counter-clockwise direction.
Repeat this action if the anti-lock function
is still active. When the anti-lock function is
deactivated, you should be able to close
the chuck without ratcheting sounds.
˜ Gear selection
m ATTENTION! RISK OF PRODUCT
DAMAGE!
Do not operate the gear selector
until the product has come to a
standstill.
Change the gear by sliding the gear selector
o
forwards or backwards (fig. F).
1 gear:
st
Suitable for:
Speed:
Torque:
2 gear:
nd
Suitable for:
Speed:
Torque:
[ 4 ]
Screwing
Low
High
Drilling
High
Low
GB/IE 43