Publicité
TROUBLESHOOTING
your dealer to carry out repair work.
Symptom
Cause
Remedy
POWER
Cannot turn power on.
@ The power plug is removed.
@ The component (stereo amplifier, audio timer,
etc.) to which the power cord is connected is off.
@
Insert the power plug correctly.
e
Turn the stereo amplifier or audio timer on.
CASSETTE DOOR
The door does not open.
@ The deck is in recording mode.
@
Power was turned off.
@
Press the stop (Ml) button.
e Turn power on.
The door does not close.
@
The cassette is not properly loaded.
@
Reinsert the cassette.
PLAYBACK
Immediately stops.
e
The tape is completely wound.
@
Turn the tape over (Play back in opposite side).
@
Rewind the tape.
The level meter does not
work,
@ The tape is not recorded.
@ The tape head is dirty.
No sound.
RECORDING
The recording indicator
does not light up.
The level meter does not
work.
© The amplifier input selector is not correctly set.
@ The amplifier volume level setting is too low.
@
Connection problems (wrong connection, cord
removed, poor contact, broken wire.)
@
The cassette erasure prevention tabs are broken.
@
REC LEVEL control is set too low.
e The amplifier is not delivering a recording signal
(from the tuner, CD player, etc.).
@
Wrong connection, connection cord removed,
poor contact, broken wire.
@
Replace the tape with a recorded one.
è Clean the head (see page 6).
è Set the amplifier input selector correctly.
@ Turn the amplifier volume control up.
@
Connect securely (see pages 9 and 10).
@
Replace the cassette with one whose tabs are
intact.
è Cover the hole under the tab (see page 7).
@ Turn REC LEVEL control up (see page 25).
@ Set the amplifier recording output selector
correctly.
@
Check connections (see pages 9 and 10).
Immediately stops.
©
The tape is completely wound up.
@ Turn the tape over (recording in opposite side).
@
Rewind the tape.
Cannot record.
@ The head is dirty.
è Clean the head (see page 6).
34
<RRE1078>
En
Publicité
