Struers Accutom-50 Manuel D'instructions page 51

Copying a Method
Accutom-50
Instruction Manual
Copying a method is a shortcut to creating a new cutting or grinding
method on the basis of an existing one.

Select the cutting or grinding method you want to copy from.
SELECT CUTTING METHOD
1.UNNAMED METHOD
3.EMPTY METHOD
5.EMPTY METHOD
7.EMPTY METHOD
9.EMPTY METHOD
11.EMPTY METHOD
F1:COPY


Press ENTER
the method parameters.

Esc Press Esc to return to the above display.


Press F1:COPY to copy the method to
F1
the buffer.

Do you want to copy method
1. UNNAMED METHOD
ENTER: YES


Press ENTER
method to the buffer.
2.EMPTY METHOD
4.EMPTY METHOD
6.EMPTY METHOD
8.EMPTY METHOD
10.EMPTY METHOD
12.EMPTY METHOD
F3:RESET F4:RENAME

if you would like to see
COPY METHOD
to buffer?
ESC: NO

to accept copying the

47