Struers Accutom-50 Manuel D'instructions page 3

Accutom-50
Instruction Manual
Accutom-50
Safety Precaution Sheet
To be read carefully
before use
1. The operator should be fully instructed in the use of the machine, its
cut-off wheels and cup wheels according to the Instruction Manual and
the instructions for the cut-off wheels and cup wheels.
2. The machine must be placed on a safe and stable support table.
3. Be sure that the actual voltage corresponds to the voltage stated on the
back of the machine. The machine must be earthed.
4. Use only intact cut-off wheels or cup wheels. The cut-off wheels and
cup wheels must be approved for min. 5000 rpm. If other cut-off
wheels, saw blades or cup wheels are used, make sure that the speed
setting of Accutom-50 complies with the max. speed for the cut-off
wheels, saw blades or cup wheels.
5. Observe the current safety regulations for handling, mixing, filling,
emptying and disposal of the additive for cooling fluid.
6. The sample must be securely fixed in the specimen holder.
7. Do not touch the sample, the specimen holder head, the cut-off wheel
or cup wheel while positioning the sample with the POSITION controls.
8. Never try to open the cover before the cut-off wheel or cup wheel has
stopped completely.
The equipment should only be used for its intended purpose and as detailed in the Instruction Manual.
The equipment is designed for use with consumables supplied by Struers. If subjected to misuse, improper
installation, alteration, neglect, accident or improper repair, Struers will accept no responsibility for
damage(s) to the user or the equipment.
Dismantling of any part of the equipment, during service or repair, should always be performed by a qualified
technician (electromechanical, electronic, mechanical, pneumatic, etc.).