Struers Accutom-50 Manuel D'instructions page 28

Stopping the Cutting
Automatic Stop
Manual Stop
24
Accutom-50
Instruction Manual

Accutom-50 automatically stops the cutting process at the pre-
set stop position. (Make sure to compensate for possible wheel
wear when setting the stop position).

The sample is then retracted and the cut-off wheel is stopped.

The cutting process can be stopped at any time during operation
by pressing the STOP
position and the process stops there.

To avoid stopping the process while the cut-off wheel still is in
the sample, press the POSITION key
then press F2:SET STOP. The sample is retracted immediately
and the process will be stopped when the relative zero position is
reached.

The display changes back to what it was before cutting was
started.

key. The sample remains in its actual

for the Y-direction and