Publicité
5
Tear assist edge
Bord de découpe
Abrißkante
Bordo guida di strappo
Opening the front cover
Lift up on the front cover and swing it open until
it stops.
To close the front cover, simply lower it back into
place.
Caution!
The tear assist edge is rather sharp. Take care to
avoid injuring your hands.
Note:
You can completely remove the front cover from the
printer or you can stand it up. You should normally
leave the front cover closed, because it protects
against objects getting into the printer, and it cuts
down on printer noise.
Removing the protective materials
Two small pieces of packing material are inserted
into the printer to protect components during
shipping. Be sure to remove them before using the
printer.
Open the rear cover by pushing it back so that the
cover swings back and down.
Remove the two white pieces of packing from
inside the printer as shown in the illustration.
A piece of cardboard is inserted into the printer to
protect components during shipping. Be sure to
remove it before using the printer.
Open the front cover.
Remove the cardboard from the inside of the
front cover as shown in the illustration.
In addition, remove the cardboard from the back of
the paper guide.
Remove the tape.
Remove the cardboard from the paper guide
as shown in the illustration.
Publicité
