Sunrise Medical QUICKIE Easy 200 Notice D'utilisation page 22

Push Handles
Height-Adjustable Push
Handles (Fig. 5.37)
These handles are secured
with pins to prevent them from
sliding out uninten tion ally.
Opening the quick-release lever
(1) makes it possible to adjust
the push handles to meet your
individual needs. As you move
the lever, you will hear a locking
mechanism; you may now easily
position the push handle as desired. The nut (2) on the tension
lever determines how tightly the push handles are clamp ed into
place. If the nut is loose after adjusting the tension lever, the
push handle will also be too loose. Turn the push handle from
side to side before use to make sure that it is clamped securely
enough into place. After adjusting handle height, always clamp
the tension lever (1) securely into place. If the lever is not
secure, injuries could result when lifting over obstacles.
Fold-Down Push Handles
(Fig. 5.38)
If the push handles are not in
use, they can be folded down by
depressing the button (2). When
they are needed again, simply flip
them back up until they click into
place.
EASY 200-300,
22
Fig. 5.37
3
1
2
Fig. 5.38
2
Pelvic Restraint Belt
DANGER!
• Before using your wheelchair ensure the pelvic restraint
belt is worn.
• The pelvic restraint belt must be checked on a daily
• basis to ensure it is free from any obstruction or adverse
wear.
• Always make sure that the lap strap is correctly secured
and adjusted prior to use. If the strap is too loose it could
cause the user to slip down and risk suffocation or cause
serious injury.
The pelvic restraint belt is fitted to the wheelchair as shown in
the illustrations. The seat belt comprises 2 halves. They are
fitted using the existing seat stay retaining bolt fitted through the
eyelet on the belt. The belt is routed under the rear of the side
panel. (Fig. 5.39)
Adjust the belt position so buckles are in the centre of the seat.
(Fig. 5.40)
Fig. 5.39
Adjust pelvic restraint belt to suit the user's needs as
follows:
To reduce the belt
length
Feed free belt Feed free belt through slide adjusters
back through male and male buckle to provide more belt
buckle and slide length.
adjusters.
Ensure belt is not
looped at male
buckle.
When fastened check space between the pelvic restraint belt
and user. When correctly adjusted it should not be possible to
insert more than the flat of the hand between the pelvic restraint
belt and the user. (Fig. 5.41)
Fig. 5.40
To increase the belt length