Publicité
GB
General technical approval/general
design approval
No. Z-40.21-565 of 9 November 2023
Rotational-moulded container combination
made from polyethylene (PE) – type: CUBE
tank 5000 l
Table 3:
Property
MFR
Yield stress
Yield strain
Young's modulus
Index a = initial value according to the general technical approval for the moulding compound (moulding
1.3
Container
(1) The tests in Table 4 must be conducted on the Container and the measured values must
comply with those in Tables 5 and 6.
Table 4: Tests and test specification
Property
Surfaces
Wall thicknesses,
container masses
Leak-tightness
Table 5:
Property
Wall thickness
(mm)
Minimum mass
(kg)
5
DVS 2206-1:2011-09
Z96891.23
52
Test specifications for moulding materials made of the Revolve 5056/N-
Unit
Test specification
g/10 min
DIN EN ISO 1133-1
MFR 190/2.16
N/mm³
DIN EN ISO 527-1
(at 50 mm/min pull-off
%
speed) (at 1 mm/min)
N/mm²
Test specification
In accordance with
DVS 2206-1
5
See Tables 5 and 6 of this
annex
See Section 1.3(2)
of this annex
Minimum wall thicknesses and container masses for containers made of the
Resinex RX103 moulding compound
Measuring
point/stipulation
In the base area
Side walls
In the upper base area
Container without
fixtures
Non-destructive tests on tanks, apparatus and piping made of thermoplastics –
Dimensional checking and visual inspection
Annex 4
Page 2 of 3
Requirement
Max. MFR =
2
MFR 190/2.16
and -2
3
4
Documentation
Frequency
Record
Every container
Measure
Inner container
Collection container
5.3
6.0
4.5
110.0
+15%
(a)
≥ 21.2
≥ 10.8
≥ 827
3.1
3.0
-
84.0
1.40.21-64/23
Publicité
