Installation - TIPTEL 272 Manuel D'utilisation

Installation

1. Line Jack Connect to wall socket using telephone cord supplied.
2. Headset Jack Western 4/4 (RJ11), use tiptel-approved headsets only
3. Handset Jack Connect handset using coil cord supplied.
Switch from SR/HV/PR1/PR2 (see chapter Message Waiting Indication)
SR: Using burst ringing signal to switch on MWI
4. Message Waiting
HV: Using line voltage above 70V to switch on MWI
Switch
PR1: Using line polarity to switch on/off MWI
PR2: same as PR1, but polarity inverted
Getting started
9
e
n
g