FLORABEST FHSA 20 A1 Traduction Des Instructions D'origine page 32

G B I E
Switching On and Off
Ensure that you are standing in a
firm position with both hands grip-
ping the hedge trimmer away from
the body. Ensure that the trimmer
is in contact with no other objects
before switching on.
Removing the blade guard:
1. Press the blade guard (
the points marked
and remove it.
Turning on:
2. Check that the battery (9) is in
(see "Removing/inserting the
battery").
3. Press the safety switch (4) at the
front handle (5).
4. Press the On/Off switch (7). The
hedge trimmer will run at top
speed.
Turning off:
5. Release the safety switch (4) or
the On/Off switch s (7).
Checking the battery charge
level
The battery's ( 9) charge level is indicat-
ed by the charge state indicator (
Press the button for state of charge display
( 10) on the battery. The LEDs indicate
the battery's charge level.
3 LEDs are on: Battery charged
2 LEDs are on: Battery partially charged
1 LED is on: Battery needs to be charged
3 2
All manuals and user guides at all-guides.com
14) at
press
10a).
Only charge the battery (
when the red LED on the charge
level indicator is on.
Working with the Hedge
Trimmer
During cutting work, ensure that no
contact is made with objects, e.g.
such as wire fencing or main plant
stems. This may result in damage to
the cutter bar.
• If the blades become jammed with
solid objects, turn the device off imme-
diately and remove the rechargeable
battery. Only then should you remove
the object.
• Avoid overstraining the equipment dur-
ing work.
Cutting Techniques
• Cut thick branches beforehand using a
branch clippers.
• The double-sided cutter bar enables
cutting in both directions or, with a
swinging action, from one side to the
other.
• In case of vertical cutting, move the
hedge trimmer uniformly forward or up
and down in an arc movement.
• In case of horizontal cutting, move
the hedge trimmer in a sickle-shaped
movement to the edge of the hedge, so
that cut branches fall to the ground.
• In order to achieve long straight lines,
the placing of tensioned guiding cords
is recommended.
9)