FLORABEST FHSA 20 A1 Traduction Des Instructions D'origine page 31

All manuals and user guides at all-guides.com
Removing/inserting the
battery
1. To remove the battery (9) from the
appliance, press the release but-
ton (11) on the battery and pull
out the battery.
2. To insert the battery (9), place it
on the guide track (15) and push
it back into the appliance. It will
audibly snap in.
Do not insert the battery until
the appliance is fully assem-
bled. Risk of injury!
Recharging the battery
Only charge the battery (
when the red LED on the charge
level indicator (
Charging time is approx. 1 hour.
1. Remove the battery (9) from the
appliance, as necessary.
2. Insert the battery (9) in the charg-
ing compartment of the battery
charger (12).
3. Plug the battery charger (12) into
a mains outlet. The red LED on the
control display (13), which is on
the charger, (12) comes on when
the battery (9) is loading. If the
green LED on the charger (12) is
on, the battery (9) is charged.
4. When the battery is fully re-
charged unplug the battery
charger (12) from the mains.
5. Pull the battery out of the battery
charger (12).
Used batteries
• If a fully recharged battery lasts for
• Always take heed of the applicable
Operating
9)
10a) is on.
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Waste Disposal and
Environmental Protection").
Wear suitable clothing and
work gloves when working
with the equipment.
Wear eye and ear protection.
Ensure that the equipment
is functional before each
use. The On/Off switch and
the safety switch must not
be held closed. They must
switch off the motor when on
is released. Should a switch
be damaged, stop working
with the equipment. Ensure
that the mains voltage value
matches the label on the
equipment.
Reduce the risk of injuries and
accidents by wearing person-
al protection equipment and
ensuring that the unit is fully
functional.
Note noise protection and local
specifications.
G B I E
3 1