Parkside PHLGA 20-LI C2 Instructions D'utilisation Et Consignes De Sécurité page 21

Initial start-up
When used for the first time, some smoke may
escape. The smoke is caused by binders which
are removed from the insulating film of the heater
by the heat during first use. To ensure that the
smoke escapes quickly, the product should be
placed on the standing position with it's battery
pack on it's base. Be sure to ventilate the work-
ing environment during first use. If the smoke/
odour is too strong, move the initial start-up to
outside!
Operation
Removing/inserting the
rechargeable battery
To remove the battery
press the release button
and pull the battery
To insert the battery
along the guide rail into the product.
6
You will hear it click into place.
Switching ON and OFF
Press and hold the release switch
Press and hold the ON/OFF switch
can let go of the release switch
uct saves the level you were working in and
starts back up in the most recently used level.
- Press the Level 0 switch
blowing air to cool down.
- Press the Level I switch
I hot air blowing. The product will reach
an air temperature up to 250 °C (by using
supplied restrictor
- Press the Level II switch
level II hot air blowing. The product will
reach an air temperature of up to 550 °C
(by using supplied restrictor
To switch off, release the ON/OFf button
The LEDs above the step switch display
14
the level at which the product is currently
operating.
from the product,
6
on the battery
7
out.
6
, push the battery
6
.
4
. You
3
. The prod-
4
for
13
for level
12
).
8
for
11
).
8
3
Keep the product in the standing posi-
tion with it's battery pack on it's base
for allowing the product to cool down after use.
Use of adapter nozzles
Before exchanging adapter nozzles, the
adapter nozzle
pipe must be sufficiently cooled down to
1
avoid burns.
Various uses are possible. Always com-
ply with the safety instructions and al-
ways handle the product with care and caution.
Restrictor
Place the restrictor
pipe . Use the restrictor
1
selective heat.
When using the restrictor
ticular attention to the heat development
at the cutting point. If in doubt, do not stay in
the same place for too long in order to avoid
overheating the workpiece.
Surface nozzle
Place the surface nozzle
pipe .
1
Use the surface nozzle
over a large surface.
When using the surface nozzle
particular attention to the heat develop-
ment in adjacent locations of the cutting point.
So that in cases of doubt, no adjacent compo-
nent is overheated.
Reflector nozzle
Place the reflector nozzle
off pipe . Use the reflector nozzle to sol-
1
der and tin pipes, as well as to shrink shrink
tubing.
.
/ / and blow-off
8 9 10
on the blow-off
8
to obtain
8
, pay par-
8
on the blow-off
10
to obtain heat
10
, pay
10
on the blow-
9
GB/IE 21