Wahl 1591 Q Mode D'emploi page 11

Operation
Preparation
Keep the packaging material for safe storage or trans-
port later.
f Check that the contents are complete.
f Check all the parts for possible transport damage.
Please note that we perform quality tests on all of our
products. Therefore, you may find small synthetic hair
on the blade set or on the machine. However, we assure
you that your clipper and cutting blade / blade set are
unused.
Safety
Caution! Damage due to incorrect power supply.
f Only operate the appliance with the voltage stated
on the nameplate.
Charging the battery
1. Connect the appliance plug on the plug-in transformer to the
charging stand socket (Fig. 2ⓐ).
Battery overcharging is prevented thanks to intelligent
charge management.
2. Connect the plug-in transformer to the mains socket (Fig. 2ⓑ).
3. Switch off the appliance using the on/off switch (Fig. 3ⓑ).
4. Place the appliance in the charging stand (Fig. 2 ).
·
During charging, the charging indicator flashes at
evenly spaced intervals.
·
After the appliance has been removed from the
charging stand, the display goes out (power saving
mode).
5. As soon as the battery is fully charged, the charging indicator
flashes at a different rate (10 on / 1 off).
Battery operation
1. Switch on the appliance using the on/off switch, and switch off
after use (Fig. 3ⓐ/ⓑ).
In case of insufficient maintenance of the blade set, the
operating time can be reduced considerably.
Operation
Cutting with attachment comb
The appliance can also be operated with an attachment comb.
f The attachment comb has 5 detent positions for adjusting the
cutting length.
f The further the attachment comb is pushed onto the blade set,
the shorter the cutting length.
The cutting length can be adjusted from 3 mm (Fig. 5ⓐ)
to 6 mm (Fig. 5ⓑ).
Attaching/removing the attachment comb
1. Slide the attachment comb onto the blade set (Fig. 4ⓐ) in the
direction of the arrow until it locks in place.
2. The attachment comb can be removed by pushing it in the
direction of the arrow (Fig. 4ⓑ).
Maintenance
Warning! Injuries and material damage due to incor-
rect handling.
f Before performing any cleaning and maintenance
work, switch off the device and disconnect it from
the power supply.
Cleaning and care
Danger! Electric shock due to penetration of liquid.
f Do not immerse the appliance in water!
f Do not allow any liquid to get inside the appliance.
Caution! Danger from aggressive chemicals.
Aggressive chemicals could damage the appliance and
accessories.
f Never use solvents or scouring agents.
f Only use cleaning agents and blade set oil recom-
mended by the manufacturer.
·
Accessories are available from our dealer.
·
Spare parts are available from our service centre.
f Remove the attachment comb (Fig. 4ⓑ) and lift the blade
set out of the housing (Fig. 6ⓐ). Use the cleaning brush to
remove any cut hairs from the housing opening and from the
blade set (Fig. 7). The cleaning lever can also be pressed. This
allows the cut hairs that accumulate between the bottom
blade and the top blade to be easily removed using the clean-
ing brush (EASY CLEANING).
f The charging contacts on the appliance and on the charging
stand should always be kept clean.
f Only wipe the appliance with a soft, slightly damp cloth.
f Oil the blade set with blade set oil (Fig. 8).
E N G L I S H
de
en
fr
it
es
pt
nl
da
sv
no
fi
tr
pl
cs
sk
hr
hu
sl
ro
bg
ru
uk
et
lv
lt
el
11
ar