Texas Equipment RMX 600 Manuel D'utilisation page 82

23. Replacing the battery
WARNING
Before attempting to adjust, repair or replace the battery, blades, or other spare parts, it is
IMPORTANT that the robot is completely turned off and that you use safety equipment in
the form of protective gloves.
Battery lifetime depends of workload, maintenance, and winter storage.
Under normal conditions, the lifetime will be up to 3-5 years. The battery is easily replaced
by following these steps:
1. Turn the robot upside down
2. Remove all grass and dirt around the battery cover before removing it.
3. Unscrew the screws which holds the battery cover. Remove the battery cover
4. Remove the battery bracket on top of the battery.
5. Carefully pull out the old battery. Press the clamp lock and release the connectors.
NOTE: Do not pull the cables. Hold the connectors and release the clamp lock.
6. Connect a new original battery by plugging in the connectors until they click into place.
7. Insert the battery into the bracket at the bottom of the chamber, put the battery bracket
and the battery cover back into its position and tighten the screws.
There is a USB port under the battery cover. This USB port should normally only be used
by an authorized service shop. But it can also be used to pull out a log file from the robot.
Make sure that no grass and dirt get on it.
82