Texas Equipment RMX 600 Manuel D'utilisation page 58

If there is a direct descent towards the boundary wire, the slope must not exceed 10°
to prevent the robot from driving over the wire, if there is low friction in the grass.
Boundary wire
o
Max slope 10
o
If the robot drives down towards the boundary wire from a gradient of more than 10 , there
must be a minimum of 2 meters from the edge of the slope to the boundary cable.
Boundary wire
o
Slope >10
Horizontal distance in cm Vertical distance in cm Tilt in degrees
o
100 18 10
Paths, driveways and tiles
If there is a walking corridor or car driving area in the robot's mowing area that is at a
different level than the lawn, it should be avoided that the robot tries to drive over this area
to get to the grass on the other side. Instead, a boundary cable should be laid at least 20
cm apart from the area/edge.
If the lawn and the walking corridor/ car driving area are in same height level, you can let
the robot drive over the area with the help of the boundary wire (see picture).
58