Texas Equipment RMX 600 Manuel D'utilisation page 74

Settings
Under settings, there are several important features that should be looked at.
• Starting point:
Instead of the robot starting in the same place every time, you can turn on a function
where you individually define 4 points where the robot starts from. If you turn on this
function, it will by default switch between 4 places along the boundary wire, where it
runs out. This partly helps to ensure that the robot runs in different patterns and covers
every area better, but it is especially an advantage if you have several zones that are
separated by narrow passages. Here you can ensure that the robot e.g., 1st time first
starts in zone 1, 2nd time in zone 2, etc. See picture. If the setting is set to 0%, then the
robot will start cutting as soon as it exits the charging station. If set to 25%, then it runs
about 25% along the total length of the boundary wire and starts from there. Same for
other % settings. The robot itself learns how far the boundary cable is. If edge cutting is
enabled, the robot will run all the way around and edge cut for the first time every day
before it starts following the selected starting points.
• Rain delay:
The robot has a rain sensor on the upper deck, which is activated by default. When the
rain sensor on the robot detects water, the robot will stop mowing grass and return to
the charging station and wait 3 hours (from the last moisture is registered) before
continuing - if it is still within the scheduled working time. The waiting time is 3 hours by
default but can be adjusted in hours and minutes. If the waiting time is adjusted, this is
confirmed by pressing "Save". If 00H 00M is selected or the function is turned off, the
robot will cut grass even if it rains.
• Firmware update:
Under this menu item you can update the robot's firmware.
Press the "Checking for update" button. If there is an update, a message will pop up
and ask for confirmation before installing. Press "Confirm" to proceed. The update will
be downloaded to your phone (takes several minutes) and will be sent to the robot if it
is within the Wi-Fi signal range. The App shows when update is completed.
• Device parameters:
Below this menu is the device information (model name and serial number).
It is possible to change the name of the robot here.
• Wi-Fi settings:
Here you can connect the robot to a new Wi-Fi network.
74