Publicité
Les langues disponibles
Les langues disponibles
Status
LED doesn't light.
The filter cleaning system is activated automatically each time the vacuum cleaner is switched on.
The filter element is cleaned automatically by a blast of air (a pulsating noise is heard).
In order to maintain continuously high suction power, in system applications (especially grinding and sanding, cutting and slitting) or
when collecting large quantities of dust, automatic filter cleaning must be activated.
Independently of automatic filter cleaning, you can clean the filter at any time by pressing the "Manual filter cleaning" button.
Power cleaning: To achieve maximum power for filter cleaning, press the "Manual filter cleaning" button while at the same time keeping
the end of the hose closed.
Technical data
Product properties
Unless otherwise stated, the values are applicable for all model variants.
Weight
Max. volume flow rate
Max. vacuum
Air temperature
Filter cleaning
Power input
Protection class
Degree of protection
Preparations at the workplace
3
Changing the dust bag
Always check the dust bag used for specific instructions relating to the application. Follow the instructions enclosed with or printed on
the dust bag.
1. Set the control switch to the OFF position.
2. Open the 2 catches.
3. Lift the suction head off the waste material container.
4. Remove the dust bag.
▶
Dispose of the dust bag in accordance with the applicable regulations.
5. Secure the holder with the dust bag to the ribs of the waste material container.
6. Fit the suction head on to the waste material container and close the 2 catches.
Connecting/disconnecting the suction hose
1. To connect, push the suction hose into the intake fitting.
2. To disconnect, twist the suction hose back and forth and pull it out of the intake fitting.
Operation
WARNING
Risk of injury. Damage to the filter system may allow harmful dust (health hazard) to escape.
▶
In an emergency (e.g. filter ruptured), switch the vacuum cleaner off, disconnect the vacuum cleaner from all power sources (remove battery
or unplug supply cord) and have the vacuum cleaner checked by a trained and qualified person before further use.
Switching the vacuum cleaner on or off
You can prolong battery runtime by activating operation with reduced suction power.
→ To activate or deactivate, press the ECO button.
You can operate the vacuum cleaner by means of a Bluetooth module and corresponding remote control unit (optional accessory).
→ Set the control switch to the BLUETOOTH position.
Read and observe the instructions on safety and use in the operating instructions of the accessory.
1. To switch on, turn the control switch to the ON position.
2. To switch off, set the control switch to the OFF position.
*2416652*
8.9 kg
(19.6 lb)
(in accordance with EPTA-Procedure 01 with large container, without battery)
Turbine
67 ℓ/s | 241 m³/h | 142 cfm
Hose end
30 ℓ/s | 108 m³/h | 64 cfm
17 kPa
(2 psi)
−10 ℃ ... 40 ℃
(14 ℉ ... 104 ℉)
Automatic, time-controlled
750 W
(1.01 hp)
I
IP X4
2416652
Meaning
The filter cleaning system is not active.
5
Publicité
