Parkside PFBS 12 C6 Manuel D'utilisation page 43

˜ Working instructions
NOTE
Take note of the correct protusion
u
distances (see "Selecting a suitable
accessory tool") .
The maximum diameter of the assembled
u
grinding bodies, grinding cones, pencil
grinders with a thread insert may not
exceed 55 mm .
The maximum diameter of sandpaper
u
grinding accessories may not exceed
80 mm .
The max . permissible length of a mandrel
u
is 33 mm .
˜ Grinding
m WARNING!
Never use a cutting wheel for grinding!
u
Hold the product at a 10 to 15° angle for
easy handling and smooth grinding results .
Apply the grinding wheel to the work
surface with a light, steady pressure for
maximum grinding efficiency . It should
never be necessary to force the product .
The weight of the product applies adequate
pressure .
Excessive pressure will overload the motor,
slow the grinding action, put dangerous
stress on the grinding wheel and causes
breakage .
Move the product back and forth steadily .
44 GB/IE/NI/CY/MT
˜ Wire brushing
m WARNUNG!
Do not use a brush that is damaged,
u
or which is out of balance . Use of a
damaged brush could increase potential
for injury from contact with broken brush
wires .
Avoid applying too much pressure which
causes over bending of wires, leading to
premature breakage .
Work with moderate feed, suited to the
material being worked .
Avoid bouncing and snagging the wire
brush, especially when working corners,
sharp edges etc . This can cause loss of
control and kick-back .
˜ Abrasive cutting
WARNING!
m
Never use grinding wheels for cutting!
u
Only use tested, fibre reinforced cutting or
grinding wheels .
Always work at a low forward speed . Apply
only moderate pressure to the workpiece .
Always use up (conventional) milling . This
will prevent loss of the product when it
leaves the cut .