Stiebel Eltron SH 50 A 2,0 230 Utilisation Et Installation page 18

OPERATION
Appliance description
2.2 General safety instructions
WARNING Burns
During operation, the tap and safety valve can reach
temperatures in excess of 60 °C.
There is a risk of scalding at outlet temperatures in ex-
cess of 43 °C.
WARNING Injury
!
The appliance may be used by children aged 8 and up and
persons with reduced physical, sensory or mental capa-
bilities or a lack of experience and know-how, provided
that they are supervised or they have been instructed on
how to use the appliance safely and have understood
the resulting risks. Children must never play with the
appliance. Children must never clean the appliance or
perform user maintenance unless they are supervised.
Material losses
!
The user should protect the water lines and the safety
valve from frost.
Note
The appliance is pressurised. During the heat-up process,
expansion water will drip from the safety valve.
f If water continues to drip when heating is complet-
ed, please inform your qualified contractor.
2.3 Test symbols
See type plate on the appliance.
3. Appliance description
The closed (pressure-tested) appliance heats DHW electrically.
You can adjust the temperature using the temperature selector.
Subject to the power supply, the water is automatically heated to
the required temperature.
The tubular heating system is suitable for hard and soft water
areas. The internal steel cylinder is coated in "anticor
and is equipped with a protective anode. The anode protects the
internal cylinder from corrosion.
Frost protection
The appliance is also protected against frost on the temperature
setting "cold", as long as the power supply is guaranteed. The
appliance switches on in good time and heats the water. The ap-
pliance does not protect the water supply lines and the safety
valve from frost.
18 | SH A
4. Settings
The temperature can be freely adjusted.
2
1 ON/OFF indicator
2 Temperature selector
• Cold
E Recommended energy saving position; low scaling
82 °C Maximum temperature setting
Depending on the system, the actual temperatures may vary from
the set value.
ON/OFF indicator
The ON/OFF indicator illuminates when water is being heated.
4.1 DHW display
2
® " enamel
1 Pointer position at maximum DHW volume
2 Pointer position with a residual amount of water
The DHW display gives you a rough estimate of the available
amount of DHW. You can reach a maximum DHW volume by set-
ting the temperature to maximum. At pointer position 2 a volume
of residual water is still available to you.
1
35
55
E
65
82 °C
1
www.stiebel-eltron.com