Abus IPCS84532 Mode D'emploi page 99

Audio link:
Send email:
CMS/Cloud notification:
Upload FTP/memory card/NAS:
Trigger alarm output:
Recording link:
7.3.4 Region exit detection
The function recognises when an object leaves a marked area and immediately triggers an event.
Preview video:
Max. Size:
Min. size:
Detection area:
Delete:
Region:
Sensitivity:
Activation of audio output on event
Sending an email. The Configuration / Event / Alarm settings / Email
item must be configured beforehand.
Transfer of the event to the event centre of the ABUS CMS software
and to an accessible TCP alarm server.
Upload an event image to an FTP server or SD card or NAS drive
Switching the alarm output in the event of an event.
Recording a video sequence to a microSD card when an event
occurs.
Configure the area to be monitored
This function is used to define the maximum size of the object to be recognised. This
is done by drawing a rectangle in the preview video. The rectangle can be drawn at
any position in the preview video.
This function is used to define the minimum size of the object to be recognised. This
is done by drawing a rectangle in the preview video. The rectangle can be drawn at
any position in the preview video.
This button can be used to draw the area to be monitored in the video image (square
area). Procedure: Press button -> set corner points with left mouse button (max. 10)
-> press right mouse button to finish drawing
Delete the area.
Number of available areas: 4
The higher the sensitivity, the smaller the objects that can be detected.
100