Simons Voss Technologies SmartHandle LockNode Guide Abrégé page 24

3. Installation
inlay again, the spring-loaded metal pin contacts the inlay
(the inlay then acts as an antenna).
Information for SmartIntego users
SimonsVoss recommends the following procedure:
1. Remove the existing LockNode.
2. Mount the new LockNode as described.
3. Open the SmartIntego Manager.
4. Select
5. Enter the new chip ID.
6. Carry out programming in the SmartIntego tool.
7. If necessary, import into the integrator system.
8. Update the documentation (installation plan).
LockNode is replaced. Do not use the old LockNode
9
anymore.
3.1 Adapter cable SO
The installation of the LockNode in the following versions of
the SmartHandle Scandinavian Oval requires an adapter
cable included in the scope of delivery:
SHB****051***3**

SHB****961***3**

SHE****051***3**

4
Replace with Chip ID.
24 / 88 | EN