Connection To The Mains; Dmx 512 Connection / Connection Between Projectors; Operation; Functions Of The Control Channels - Futurelight GENESIS Série Mode D'emploi

3.2 Connection to the mains

Connect the projector to the mains with the lead supplied:
- Brown: Live (Phase)
- Blue: Neutral
- Green/Yellow: Earth

3.3. DMX 512 connection / Connection between projectors

4. Operation

4.1 Functions of the control channels

I. Channel 1 - PAN
II. Channel 2- TILT
The electric connection must be carried out by a qualified employee.
The wires must not come into contact with each other, otherwise the
projectors will not work at all, or will not work properly.
Push slider up in order to move mirror horizontally (PAN).
Gradual mirror adjustment from one end of the slider to the other
(0-255; 128 = center).
The mirror can be stopped at any position you wish.
Push slider up in order to move mirror vertically (TILT).
Gradual mirror adjustment from one end of the slider to the other
(0-255; 128 = center).
The mirror can be stopped at any position you wish.
Connect the controller to the projector or one
projector to another only by a stereo shielded cable
and a 3-pin XLR-plug.
Caution: At the last scanner, the DMX-cable has to
be terminated with a 120 Ω resistor. Solder the
resistance into a 3-pin XLR-plug and plug it in the
DMX output of the last scanner.
CHANNEL FUNCTION
1
2
3 COLOURS
4 GOBOWHEEL 1
5 ROTATION
6 GOBOWHEEL 2
7 DIMMER/STROBE
8 SPECIAL EFFECTS
19
PAN
TILT