Gobo-Colourwheel
Lampholder
3.1 General instructions
When installing the device, make sure there is no highly inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
The projector can be installed in any postition without altering its operation characteristics.
Ensure that the structure to which you are attaching the projector is secure!
For fixing the projector use the hole provided in the bracket. The hole in the adjustable mounting bracket has a
diameter of 8mm.
For overhead use, fit a safety chain or cord.
3.2 Connection to the mains
The electric connection must be carried out by a qualified employee.
Connect the projector to the mains with the lead supplied: Mains plug
Make sure that the wires do not get into contact with each other.
Otherwise, the scanner will not work at all or not work properly.
3.3. DMX 512 connection / Connection between projectors
Connect the controller to the projector or one projector to another only by a stereo shielded cable and ¼ „ stereo
jacks.
Switch on the device with closed housing only!
3. Installation
DANGER OF FIRE !
During the installation do not touch the glass-bulbs bare-
handed! Please follow the lamp manufacturer's notes!
Before you close the housing again, make sure that the lamp
is installed tightly into the lampholder system. Reclose the
housing and tighten the fastenig screws.
Caution !
Caution !
1 3